Build a permanent magnet dc servo motor driven by a full-bridge

/in /by

 Consider a permanent magnet dc servo motor with the following parameters: 

Tem(rated) = 10Nm

Don't use plagiarized sources. Get Your Custom Essay on
Need an answer from similar question? You have just landed to the most confidential, trustful essay writing service to order the paper from.
Just from $11/Page
Order Now

 Rated Speed in rpm Nrpm = 3700 

kT = 0.5Nm/A 

kE = 0.5V/rad/s 

Ra = 0.37Ω

 La/Ra = 4.05 × 10−3 s 

Jeq = 0.0079kg-m2 

The servo motor is driven by a full-bridge four-quadrant dc-dc converter operating from a 200V dc bus. The motor is delivering a torque of 5Nm at a speed of 1500rpm. The switching frequency is 20kHz. 

1. Build the above dc motor and power electronic converter in Simulink. 

Using the simulation model, determine the peak-peak ripple in the armature current for the above operating condition in open-loop? 

2. Design the current loop for a crossover frequency of 1kHz and the speed controller for a crossover frequency of 100Hz. 

3. Build the closed loop model in Simulink. In the model, For a step increase in load torque from 5Nm to 10Nm, with the speed reference at rated value, plot the response of the system speed and armature current.